A Step-by-step guide to DIY a Plant Stand
Welcome to our DIY blog! In this edition, we're thrilled to present a step-by-step guide provided by our talented DIYer, Cheryl Perkins. From essential supplies to the precise cut list, from mastering the cutting process to effortless assembly, Cheryl's expertise will guide us through every step. Get ready to elevate your greenery game with this fun and fulfilling DIY plant stand!
Supplies
Cut List
(A) 1 – 1" x 7 5/8” x 17” - bottom shelf
(B) 1 – 1" x 6" x 17” - middle shelf
(C) 1 – 1" x 4 ½" x 17” - bottom shelf
(D) 3 – 1" x 1 ½" x 17” - back boards for shelves
(E) 2 – 1" x 1 ½" x 6 7/8" - sides for bottom shelf
(F) 2 – 1" x 1 ½" x 5 1/4" - sides for middle shelf
(G) 2 – 1" x 1 ½" x 3 5/8" - sides for top shelf
(H) 2 – 1" x 1 ½" x 24 – side back supports for stand
(I) 2 – 1" x 1 ½" x 25 – side front supports for stand – 12 degree mitre cut at each end [shelf width and side board lengths may change depending on wood you use – these are based on using a 1” x 10” x 8’ from Home Depot]
(J) 1 – 1" x 1 ½" x 3 ¼" bottom space jig
(K) 1 – 1" x 1 ½" x 5” shelf spacing jig
Cutting
1. Select your board – I use a 1” x 10” x 8’ knotty pine shelf board from Home Depot at a cost of $13.94
2. Square the end of your boards before cutting.
3. Cut a 1 ½" x 8’ strip from the edge using the table saw.
4. Move board to the mitre saw, measure and cut your first shelf at 17” long
5. Move back to table saw and cut another strip at 1 ½"
6. Move back to mitre saw, measure and cut your middle shelf at 17” long
7. Move back to table saw and cut another strip at 1 ½"
8. Move back to mitre saw, measure and cut your top shelf at 17” long
9. From the 1 ½" x 8’ (A) strip cut this into 3 back pieces and the 6 shelf sides and the 3 ¼" jig
10. From the 1 ½" x 79” (C) cut this into the 2 pieces for the back side supports, 1 side front support and the 1 jig at 5”
11. From the 1 ½" x 62” (D) cut the 2nd side front support
12. You will be left with a board approximately 6” x 45” and we can use this for a quick kitchen shelf !
Assembly
1. Take the bottom shelf board – 1 back piece and the 2 side pieces – lining up the back and shelf flush glue and nail. Using your square line up flush the side pieces glue and nail – repeat for 2 remaining shelves.
2. It is easier to apply stain at this point before final assembly – stain shelves and side supports
3. Using the small jig set bottom shelf in place – check for level and glue and nail in place. I use 4 nails on the outside and add one on the inside.
4. Using the 5” jig attach 2 remaining shelves and repeat for other side.
5. Using the small jig place under shelf – this should make it level and attach front side supports – checking for level at each shelf.
6. Add a clear coat – let dry and enjoy your stand
